How to measure the quality of linear motor, then we need to use a multimeter to measure the use of multimeter to determine single-phase or three-phase motor is not burned method is only applicable to the coil winding DC resistance of more than 1 Euro small motor.
1. Three-phase motor is burned out of the judgment method is relatively simple, with a multimeter to test the three-phase winding DC resistance is balanced, if the imbalance can determine the three-phase motor is burned.
2. The single-phase motor start winding DC resistance is greater than the operating winding, the easiest way to determine is;
⑴ first with a multimeter were measured public end to run the winding end and the start winding end of the DC resistance
⑵ Then use a multimeter to measure the end of the winding to run the winding DC resistance.
⑶ If the two measurements in ⑴ and ⑵ and the measured value is not equal, then the linear motor must be burned. If the same, it is best to compare with the same type of linear motor, or find the linear motor factory parameters for comparison. To determine the quality of linear motor, add that the amount of single-phase motor should disconnect the capacitor. Single-phase motor is a short circuit you have a normal case of resistance as a reference. Simply use the smell and look at the two methods is good.
In summary, I hope we can help you more easily use the linear motor, as the leader of linear transmission, we have been focused, professional. Everyone in the late course of what is not clear where you can feel free to call our company: 400-007-7724
This article originates from Kunshan Tongmao Electronics Co., Ltd. (
www.tmmotion.com) original company, please indicate the source.
Linear motor